Skip to main content
Skip table of contents

Transportation - Tariff Configuration Error for Volume Tests

🤔 Problem

The client has indicated that tariffs were not being accurately valued for both sides of a volume test on tariffs. The 'Volume Tests' associated with a tariff enable the system to apply varying rates based on volume throughput. In this instance, the client requested that both fees be charged once the commitment was fulfilled, rather than applying a uniform rate to all volumes. We can see from the below screenshot, the below logic was in place to determine which rate to charge.

🌱 Solution

The issue at hand was ultimately a setup error regarding the tariff details. The incorrect configuration included two volume test numbers (1 and 2) when there should have been only one setup to account for both under and over rates. For each tariff detail, there should only be two Volume Test records when there are more than two tiers within a tariff.

image-20250519-122320.png
    1. To accurately value the rates, the initial setup change required was to adjust all instances of ‘Volume Test Number’ to a value of 1.

    2. Additionally, it was necessary to remove ‘Volume Tests’ number 2 from the user interface, as this setup was not applicable for the current use case.

image-20250519-122146.png

In the tariff details, there is a checkbox labeled ‘Apply to All.’ When this box is checked, the commitment rate will be applied to all volumes within that specific tariff detail. However, in the scenario mentioned above, the intention was to charge multiple rates, so the 'Apply to All’ checkbox was left unchecked.

📎 Related Tickets

WESS-15646

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.